Search the Community

Dear AL Friends I am in struggle with an issue on my Allion 240,hope expert AL members will give better solution to escape from this problem.... Here i list my scenario 1. Yesterday after few miles run i saw oil leakage on engine bay. after investigation it is near oil control valve then i saw it to mechanic and he remove OCV , and sealed with 999 sealant. And also inform me to use water pump and clean previous oil leak areas( not engine area) 2. Then i travel to home without any issue and cleaned oil leak area from water pump and paste 999 sealant near ocv value area thoroughly. 3. Then after few minutes travelling Check Engine bulb start blinking. then i removed battery wire(-) around 20 mins and start. Then Check Engine bulb goes off. Again i start driving another 20 mins it shows again. 4 . Then i went to mechanic again and scan. it shows VVT system malfunction error, then he erased it and after another 20 mins driving engine lights ON. I notice after 10-20 mins driving that light blink after i search forums i found two reasons. 1. OCV issue 2. VVT sensor issue My dear AL friends what will be the issue behind this..Hope u all help me Thanks